What is a swamp cooler pump

These water distribution lines are located at the top of the evaporative pads and pour water through them. If the homeowner feels that the air isn’t cool enough, they can turn their swamp cooler’s switch to “pump” to pump more water into the evaporative pads.

Can I run my swamp cooler without the pump on?

Yes, the fan and pump motors are separate systems. You can run one without the other with no damage to the product. That said, however, you will not receive the same degree of cooling by only running the fan.

How much does it cost to replace a swamp cooler pump?

Part replacementAverage cost (including labor fees)Motor$120-$650Pump$150-$450

What is the difference in swamp cooler pumps?

Swamp Cooler Terminology Unlike the air conditioner which uses British Thermal Units as a measuring stick to tell how much coolant it is using, the swamp cooler uses CFM. This stands for Cubic Feet per Minute that the cooler is blowing into the home. Knowing the CFM will help you determine if the pump is large enough.

How long should I run the pump on my swamp cooler?

You also want to only run the pump for as long as you have water in the reservoir. Running the pump without water will overheat the pump, causing it to burn out. If you run out of water, most evaporative coolers will run the fan without water, but this is for recirculating air and won’t truly cool it.

Why does my swamp cooler pump keep going out?

Your problem may be a lack of water, rather than a broken pump. Check to see that the pump is getting power. Some pumps plug directly into a standard electrical outlet, and some are wired inside of a box in the cooler. If the pump is not getting power, check the circuit breaker or the ground fault circuit interrupter.

Is it okay to leave a swamp cooler on all the time?

You can run your swamp cooler all day should you so choose without seriously increasing your monthly utility bill. However, you will need to be available to refill the reservoir in the interim. Should you not want to do that, run your swamp cooler first thing in the morning or overnight to fill your home with cool air.

How big of a swamp cooler pump do I need?

Checking unit size If you can’t locate the CFM number on your evaporative cooler or in the owner’s manual, the following formula will help you calculate it: Multiply the square footage of your home by the average height of the ceiling (in feet). Divide by two (air changes per minute).

What happens when swamp cooler runs out of water?

All Portacool Cyclone, Jetstream, Hurricane and Hazardous Location evaporative coolers come with an automatic low water shutoff. When the evaporative cooler is out of water, a red light will illuminate on the control panel and the pump will shut off.

How many windows should you open for a swamp cooler?

Open the windows or vents on the leeward side of the house to provide 1 to 2 square feet of opening for each 1,000 cfm of cooling capacity.

Article first time published on

How can I make my swamp cooler colder?

Use Your Swamp Cooler in a Dry Climate. …
Use Your Swamp Cooler Seasonally. …
Open the Windows. …
Run a Dehumidifier. …
Cultivate a Green Thumb. …
Experiment With Positioning. …
Prime the Pads First. …
Use Cold Water.

What is better swamp cooler or AC?

For budget savvy consumers, the swamp cooler is the more economical choice for summer cooling. Central AC does require some maintenance, but this is mostly clearing away debris from the compressor and making sure that the air filters are changed. Evaporative coolers require much more maintenance.

How much is a new motor for a swamp cooler?

Swamp Cooler Motor Replacement A motor replacement costs anywhere from $50 to $600.

Does a swamp cooler use a lot of electricity?

Electricity. Swamp coolers use very little electricity. They only need enough energy to power the fan and a small pump. So they can almost always run on normal household currents.

How do you know if your swamp cooler pump is bad?

Your Swamp Cooler Isn’t Starting or Has No Air Flow. …
There Are Weird Odors Coming From The Unit. …
The Airflow Isn’t Working Right. …
The Swamp Cooler is Leaking.

How do you test a cooler pump?

The only way to accurately determine if your Liquid Cooling Pump is functioning, is by checking the Pump RPM. This will only be possible if the pump cable is connected directly to a fan header on the motherboard.

Why is my swamp cooler not getting cold?

Probably the single most common reason your swamp cooler is not blowing cold air is that the circuit breaker has tripped or the fuse has blown. … Another possibility when your cooling unit isn’t blowing cold air is that you have a problem with either the fan motor or the belt.

How do I prevent calcium in my swamp cooler?

Make sure they replace parts that have been overcome with hard water and will reduce the cooling ability of the cooler. If you have mild hard water issues it is a good idea to get an inline filter to reduce calcium and mineral buildup in your cooler.

Is a bigger swamp cooler pump better?

You can use larger pump, that delivers more water through the cooler pads, that have higher water retention ability now. The water flowing per second through the cooler pads will be increased. As a result, you will get higher evaporation.

Do swamp coolers work in high heat?

Here’s the deal: your swamp cooler will only cool your home by about 10 degrees. In addition, it will struggle immensely, and likely will not work at all, when its humid outside.

At what temperature do swamp coolers stop working?

A wet bulb temperature above 70 degrees Fahrenheit (21 degrees Celsius) means the swamp cooler won’t be able to adjust the temperature enough to keep it in the comfort zone. (This varies based on humidity, personal preference and activity, but it generally falls in the low 70s.)

Do swamp coolers work at night?

Evening hours are a great time to run the swamp cooler. You can optimize airflow for dinner-time comfort and relief.

How often should swamp cooler pads be replaced?

Cleaning your pads annually helps manage mineral buildup, makes the pads last longer, removes foreign matter (like cottonwood seeds) and improves efficiency. For Mastercool swamp coolers, you should clean the pads annually and replace them every 3-5 years.

How do you clean a swamp cooler pump?

Clean the equipment regularly using a mixture of white vinegar and water. Clean the water reservoir at the bottom of the cooling unit at least once a month during summer to keep deposits at bay. When cleaning, you should turn off the cooling unit, then scrub it with a stiff brush soaked in water and vinegar mixture.

Why is my swamp cooler blowing out hot air?

In an evaporative cooler, water saturates absorbent pads. A fan blows hot outside air across the pads causing the water to evaporate and cooling the air. If there’s not enough water, the cooler won’t work right. … Check the pads—Many times a problem with the absorbent pads causes a swamp cooler to blow warm or hot air.

Can a swamp cooler catch fire?

Evaporative coolers are an economical way to beat the dry desert heat. But a box full of straw, electricity and water can be a rooftop fire hazard. … Firefighters say an electrical problem with the motor started the fire.

Do swamp coolers work?

A swamp cooler is energy-efficient and an affordable cooling devices but they only work well in certain areas where there is low humidity. When the humidity level hits 30% l swamp coolers are going to slow up their cooling capacity, and when you hit 35% they basically stop cooling.

Which cooler pump is best?

BrandZOLTAModel NameKhaitan Submersible Pump for Desert Air Cooler, Aquarium, Fountains, 18W, 1.6 m, For Cooler And FountainTypeSubmersibleUsage TypeDomestic

Why does my swamp cooler smell fishy?

The most common reason for a fishy odor is usually bacteria or mold build-up and microscopic algae. All of these come from spores in the air that find their way on air currents into the unit. Cleaning the unit will usually remove the fishy odor resulting from the growth of these spores.

How much humidity does a swamp cooler add?

How much moisture will an evaporative cooler add to the environment? An increase in humidity of approximately two to five percent is produced depending on the temperature and humidity of the environment. This increase is not noticeable in a ventilated area where the air produced by the cooler is exhausted.

Can you put ice in your swamp cooler?

Ultimately, it is up to you whether you put ice in your evaporative cooler. Most likely it won’t hurt anything – we say most likely because theoretically your pump could suck up a piece and seize up. You just have to weigh if you think it is worth a 2°F temperature difference over a 30-minute time period.